Searched to no avail. Currently printing a vase I found on Thingiverse for my wife in t-glase (PETT, Taulman). I've seen tricks for cleaning up ABS prints with acetone. Is there something like that for PETT? It's already pretty glossy, the goal would be to make the surface smoother without sanding. Sanding this particular shape might be a lost cause:
Announcement
Collapse
No announcement yet.
T-glase post-print cleanup?
Collapse
X
-
Guest
Comment
-
I didn't think to take a before pic sadly, but there was quite a bit of layer texture on the outside walls that was very noticeable. if you zoom in on the pic the inside is not coated, and I did lightly sand the inside for good fit of the speed control box that's going in it. I can't wait to see what it will do for the Blue T-glase I ordered for my Toyota Emblem project.
Comment
-
Guest
Comment