Announcement

Collapse
No announcement yet.

Ender 3 pro issues.... Also hello all!!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Ender 3 pro issues.... Also hello all!!

    I had 2 good prints that where already on the SD card. Now when I try to print i get a mess. Is will not print properly. It won't let me upload a photo on mobile.. So it is just printing a mess. Could it be the filament? Any help would be great. Thanks everyone!!!

    #2
    Can you upload a photo from your computer? It's hard to say what the problem is, most possible a poorly leveled bed. It usually isn't the filament.

    Comment


      #3
      Could just be the same problem I have/had. The fan for the hot end was dead. Check the two fans on the carriage are running.
      PLAx3

      Comment


        #4
        I will see what I can do as far as loading a photo... And I will check the fans to see.. just didn't make sense that is printed 2 perfect prints then started printing bad.

        Comment

        Working...
        X