Welcome guest. Our website uses cookies to ensure you get the best experience on our website, click here to learn more. To post a thread or reply you must be a member. Registration is fast, simple and absolutely free. So please join our community today!
Good morning! Just got my printer up and running, but every time I go to heat the bed and extruder, the lcd displays "heater decoupled". All wires are good, ideas? Also, when it goes to print, it's about 2 inches from the bed, recalibrate Z?
2 inches? ok thats a long way off. I'd be wondering if something serious has broke.
Start by calibrating the z axis and see if that fix's it, but be prepared it may be a bigger fix than that
you say you only just got it running? Can you return it as faulty, that sounds like a faulty heater to me
When i instelled my cooler, had this problem. The table temperatures was long out of temperature safety limit.
I needed to change the range temperature safety.
Temp_hysteresis 10
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment