Announcement

Collapse
No announcement yet.

Ultrabase heated bed dropping temps.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Ultrabase heated bed dropping temps.

    hello, I have got a brand new Anycubic Mega S and have discovered a problem with the ultrabase print surface. I have it set to 60degC The first 3 prints I did went really well without any problems and about halfway through the fourth one I connected the printer to the drivers on my laptop which stopped the print and was unable to resume so I restarted the printer and the print. And since then about every 15/20 minutes the printer sets the temp to 0degC and starts to drop. But I can pre heat it back to temps on the laptop and it will stay at 60degC but 20 mins later it happens again. Also ever since I first connected the laptop I have kept using it. Didn’t have this problem beforehand so I’m not sure wether it is the driver, Cura settings or maybe even needs a firmware upgrade. What do you guys think?

    Thanks.
Working...
X