Announcement

Collapse
No announcement yet.

Combining infill layers on Slic3r

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Combining infill layers on Slic3r

    I am experimenting with print times vs quality and the combine infill layers on slic3r is not behaving as I would expect. I have a 1.5mm layer height for the perimeters and I have set to combine infill every 4 layers. The gcode generated only combines infill every two layers. My nozzle is 0.4mm and the infill extrusion width is 0.59mm (apparently 0.6mm is not allowed as it is too large). Any ideas why it only combines 2 layers?

    Cheers

  • #2
    I would think a 1.5mm layer from a 0.4mm nozzle could be asking a bit much, try a smaller layer height, there is a max height you can extrude per nozzle width

    Comment


    • #3
      Yeah, that was supposed to 0.15

      Comment


      • #4
        Oh yes, I did solve it and it is a limitation within slicer to do with max layer height and nozzle width as you suggest.

        Comment

        Forum Sponsors

        Collapse
        Working...
        X