Hello everyone!
When printing with dual extrusion in Simplify3D you have to create two processes for each material and can set a different fan speed for each.
But there is also the option to use a different hotend each for the part and the support (if doing so there is only one process).
Is there a possibility (or makeshift solution) to set different fan speeds when printing support and part?
In my case I was trying to print a nylon part with a PLA support.
Any ideas?
When printing with dual extrusion in Simplify3D you have to create two processes for each material and can set a different fan speed for each.
But there is also the option to use a different hotend each for the part and the support (if doing so there is only one process).
Is there a possibility (or makeshift solution) to set different fan speeds when printing support and part?
In my case I was trying to print a nylon part with a PLA support.
Any ideas?
Comment