Announcement

Collapse
No announcement yet.

problem with Geeetech Rostock mini G2S

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • problem with Geeetech Rostock mini G2S

    please help. I lose on the next day. the printer is new. just made up according to the instructions. Problem setting bed. one engine is not going up and buzzes. in settings, you can move it. how to fix it?

    my printer is Geeetech Rostock mini G2S .

    here is my problem:
    https://youtu.be/r26j1kd5WfA
    https://youtu.be/r26j1kd5WfA

  • #2
    Probably a stupid question, but have you double checked the cables to make sure it is plugged into the correct connector on the board?

    Comment


    • #3
      everything works correctly as it enters the manual control. You can normally move up and down each engine, but it can not be calibrated, during calibration moves like in the video

      Comment


      • #4
        Have you checked to ensure the proper current is getting to the motor? Most boards have a trip pot for the motor control that you can adjust. Do some research and see what yours should be set at. Then check the voltage differential and see if it matches.

        Comment

        Forum Sponsors

        Collapse
        Working...
        X