I am having a lot of trouble with my first layer, so much so that I cannot get past printing the brim. I have no idea what the problem is, so I've taken a picture of a print that I tried just now and was hoping that someone could maybe try and identify a problem. I've looked all around the internet and have not found this problem anywhere else.
My printer is the Anet A8 and I have replaced the hot-end a few times since I got it.
It printed perfectly when I first built it, and now a few months later it's having these problems.
Here are some pictures:
https://drive.google.com/open?id=0By...DFBaDAtOVRsQXM
https://drive.google.com/open?id=0By...G9UX3RrX1BOT00
My printer is the Anet A8 and I have replaced the hot-end a few times since I got it.
It printed perfectly when I first built it, and now a few months later it's having these problems.
Here are some pictures:
https://drive.google.com/open?id=0By...DFBaDAtOVRsQXM
https://drive.google.com/open?id=0By...G9UX3RrX1BOT00