I bought this spool of NinjaFlex to try out on my school's 3D printer. I had some problems getting it to print due to the style of printer I was using (bowden tube style). Now that school is over, I have no printer to print it with. Due to the fact that the material did not work in my printer, I barely used any of the material at all. I would estimate that only a gram or two was used, so the roll is basically completely full. Barely any of the filament was used as I could not get the printer to extrude the material at all and would just drop dots of filament here and there. The filament has been re-wrapped and then stored in a Ziploc with a desiccant packet, so you do not have to worry about any moisture issues.
This spool is the .75kg of Midnight black.
The material was ordered from Matterhackers.com on 05/01 for $65.00
Since barely any of the filament was used I am looking to charge $50 for the spool.
Let me know if you have any questions or interest!
Thank you
This spool is the .75kg of Midnight black.
The material was ordered from Matterhackers.com on 05/01 for $65.00
Since barely any of the filament was used I am looking to charge $50 for the spool.
Let me know if you have any questions or interest!
Thank you
Attached Files