Announcement

Collapse
No announcement yet.

This is part of a 2 day print.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    This is part of a 2 day print.

    This is part of a big 2 day print. Using atomic petg, on an Ender 3. I did the heat tower test from 260 to 240C, and 255 turned out the best. So this is at 255C, 20mm print speed. Other than just cranking up the extrusion rate, what could it be? Bumping the temp to 260 things get really globby(which you can see part of). I'm using cura as my slicer
Working...
X
yobit