Announcement

Collapse
No announcement yet.

Bed levelling every time I print

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Bed levelling every time I print

    Hi - I just bought an Ender 3 Pro and I've had a few successful prints but things are going wrong now so I'm going back to basics and making sure all my calibrations are right. One thing I've found is that I have to adjust the bed level every time I print - is this normal? It's usually the front left corner that needs to be lowered but then of course the other 3 corners need adjusting too.

    Thanks

    #2
    I had the same issue on my Ender 3 v2 and BLTouch. I worked out that there was an issue using octoprint to run a bed visualiser test and then straight away again without adjusting anything. The readings were different.

    My issue turned out to be the bed was a little loose on the channel and tightening the eccentric nuts to remove the slight wobble fixed mine.

    Also, if you have customised your FW, may sure your levelling code is not set to run too fast as this can sacrifice accuracy.

    Comment

    Working...
    X