Announcement

Collapse
No announcement yet.

Ender 3 odd bed issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Ender 3 odd bed issue

    What is causing this? Anytime I try to print something with a large footprint it does this. What I find odd about it is the fact it is always contained to the one side and/or triangle depending on how it is sliced. I’m printing on glass and with a BL Touch, and a mesh analyzer shows my tolerances are less than .01 mm off. It does this no matter where I print on the bed. I’ve lowered bed temp and even raised nozzle temp. Could this be a slicer issue?

    #2
    It could be a slicer issue. I had one version of Cura that would't lay the object flat on the print bed unless I actually clicked that command.
    In Cura if you rotate the view to the underside of the bed you should see the complete surface highlighted in red where it touches the print bed. If its not all red then the print is tilted.

    Comment

    Working...
    X