Announcement

Collapse
No announcement yet.

3D print looks awful

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    3D print looks awful

    Hello, I have been 3D printing for a little bit now and I’ve had lots of good prints. I use the Monoprice Select Mini, it has been working fine for me, but yesterday I started a print of a Death Star spinner to go on the top of the 3D printer, and it turned out looking like this:
    See bottom


    If you know a solution to this please help.
    Thank You in advance.

    The original was supposed to look like this:
    https://www.thingiverse.com/thing:2189584/comments

    #2
    I think it is your z steps per mm. I only know because I had a print that looked like that and that was my problem.

    Comment

    Working...
    X