Hi All
im printing some discs 100mm diameter, 10mm wide and 10mm high, with a brim
the finish is good apart from this lump on the side
From what i can work out when the brim is printing , it goes in a circle then steps inside 0.4mm to make the next circle, but this continuing with the component, any ideas to stop this, ill try a skirt, but the brim does work good
Thanks Dean
im printing some discs 100mm diameter, 10mm wide and 10mm high, with a brim
the finish is good apart from this lump on the side
From what i can work out when the brim is printing , it goes in a circle then steps inside 0.4mm to make the next circle, but this continuing with the component, any ideas to stop this, ill try a skirt, but the brim does work good
Thanks Dean