Announcement

Collapse
No announcement yet.

Step in side of extruded disc

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Step in side of extruded disc

    Hi All
    im printing some discs 100mm diameter, 10mm wide and 10mm high, with a brim
    the finish is good apart from this lump on the side
    From what i can work out when the brim is printing , it goes in a circle then steps inside 0.4mm to make the next circle, but this continuing with the component, any ideas to stop this, ill try a skirt, but the brim does work good
    Thanks Dean
Working...
X