Announcement

Collapse
No announcement yet.

Strange Print Notches

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Need Help: Strange Print Notches

    Hi,
    I am new to 3D printing and am experiencing some difficulty with my Creality Ender 3 printer.

    In my prints I am getting there wierd notches Iím my prints that I am unable to explain (see image attached)

    Any my help would be apreciated

    #2
    Recheck your platform, Iím new at 3D Printing but it almost looks like the nozzle is catching the right edge and not low enough on the left side, checking to make sure the platform is level is where I would start and then check lay flat in the program if thatís applicable, other then that ?.
    Last edited by Imold; 12-24-2018, 10:44 PM.

    Comment


      #3
      How old is this filament and what filament is it and was it left exposed to air for a while.?

      Comment


        #4
        I'd say your retraction settings need looking at. The print troubleshooter at rigid.ink might help here.

        Comment


          #5
          It's too much heat, they are blobs/zits cause by excess heat

          Comment

          Sign Up

          Collapse

          To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
          Working...
          X