Announcement

Collapse
No announcement yet.

i dont know anything about it

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • i dont know anything about it

    hello
    i purchased one 3dprinter https://www.3dprintersonlinestore.co...usa-i3-diy-kit
    assembled it.
    but i dont know how to configure it
    can anyone help me? and make it work .
    one more thing on the sellers page it showed they are going to send RAMPS board but they sent makeboard and it shows micromaker on display
    on their manual they shows connections should be like
    red- 2B but these are for old model their customer support is worst
    blue- 2A
    Green-1A
    black-1b

    and now when i connect the motor connectors to board connections goes like
    red-1B
    Blue-1A
    green-2A
    black-2B

    http://imgur.com/a/0sUns

    please help

    its my first 3d printer
    thanks
    i'm waiting

  • #2
    the key thing about steppers is that each phase/winding is connected together in your case red and blue are one winding and green black the other whether it be 1A or 2A but the motor may run reverse direction to go into more config detail would be better done if you web search the exact printer especially on youtube or if all is wired right and your feeling lucky power it up and let us know what happens

    Comment

    Sponsors

    Collapse
    Working...
    X