Announcement

Collapse
No announcement yet.

Introduction

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Introduction

    Hello everyone! I’m a rookie in the 3D printing world and have not been able to print anything as of yet! I just finished building a Prusa I3 Mk3s and cannot get it to calibrate properly on the x axis. When I select the xyz calibration it goes off without a hitch. So only the X axis in self test mode. I have adjusted belts, bearings, and wiring harnesses. I have even greased the rods just in case. I’m at a total loss, can anyone help?
Working...
X