Announcement

Collapse
No announcement yet.

New to 3d printing

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    New to 3d printing

    Just purchased a Geeetech A30 and have done a few prints. Still using East Print 3d for slicing but it is limiting me to printing 2 objects at a time.
    It did take a while to update firmware and get Easy print 3d software to work.
    The prints are not bad.
    I need to tweak the settings and learn more about 3d printing.
    Any reccomendations on better slicing software that would generate a working g code for this printer would be appreciated.

    Pics below

    1st print was the included file on sd card.
    The heat bed was loose in the back. I couldn't get the rear 2 nylon bearing wheels to engage the track.
    Tightening them and tweaking the eccentric nuts to the max did not help.

    I then realized that 1 of the bearings on the nylon wheels with shot.
    I replaced that Wheel And it did help But I still can't get both of the rear wheels To engage the track At the same time. I am able to tighten one in get it to engage But not both at the same time period. The bed does appear to be stable now.

    2nd print/pic
    This is one of the Davinci theoretical perpetual motion wheels. The tape measure is on inches.
    That is the largest I could get it with standard settings

Sign Up

Collapse

To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
Working...
X