I have a Prussa i3 v2. I am having a blast with it and am really learning a lot. I’ve been able to over come all issues until now. I can successfully complete 8 hour prints consistently BUT, when ever I need to use supports my printer always stalls for lack of better term. The heater stays on along with the cooling fans but the hot end and bed stop moving. This only happens when I generate support materials. Any thoughts or advice would’ve greatly appreciated. My only guess is maybe my RAMPS are over heating? If so how could I confirm this as my Repetier host does not give any faults or warnings in the fault log to point me in any helpful direction.