Announcement

Collapse
No announcement yet.

Hello everyone, I have a Firmware issue.....

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Hello everyone, I have a Firmware issue.....

    Hi, I am new to this forum but was hoping someone had some advice on my issue

    I have noticed that after upgrading my CR10-s to Marlin 1.1.9 I cannot set my nozzle temp beyond 235C, despite having set the max temp to 250C in config.h (HEATER_0_MAXTEMP 250) I am fairly sure I could go higher than 235C before the update. (donít know if someone with a cr-10s on stock firmware could confirm this?)
    I have also noticed that the PLA+ I am printing with seems to go down noticably better when set to a higher temp than what I had previously used for the same roll of filament before updating.
    I am wondering if the printer could be reporting a higher temp than what the nozzle is actually reaching, and if that is related to whatever stopped me going beyond 235C?

    #2
    Thanks for sharing this

    http://www.121techsupport.co/garmin-...armin-support/

    Comment

    Sign Up

    Collapse

    To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
    Working...
    X