Announcement

Collapse
No announcement yet.

Hello, New Geeetech I3 Pro B

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Hello, New Geeetech I3 Pro B

    Hi guys,

    I just bought my first 3D-printer I was looking to get one for a hobby so I didn't go for a super expensive one, the Geeetech I3 Pro B was relatively cheap. I have a few problems, the print quality isn't super good, I know its a cheap printer so I shouldn't expect much but it seems to be worst than it should be. On top of that, I ran a 3D-benchy test and the walls seem to sag and the infill doesn't seem to stick well. I have leveled the bed and made sure the extruder is clean. the first layer is pretty decent but near the end the quality gets bad. any modifications and firmware fixes would be greatly appreciated.

    #2
    watch tom's 3d benchy video he tells why things are off with it. If you are using Slic3r their manual gives a guide what all settings do and some troubleshooting guides also a pix of your print would help

    Comment

    Sign Up

    Collapse

    To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
    Working...
    X