Announcement

Collapse
No announcement yet.

Using Cura 2.6.2 to print a Huge Dog on the Geeetech Aluminum I3

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Using Cura 2.6.2 to print a Huge Dog on the Geeetech Aluminum I3

    https://youtu.be/74T-NBVLeKU

    #2
    Could you have rotated it 30-40 degrees or so and printed it a bit bigger?

    Comment


      #3
      That's a good idea. It might have worked. I'll have to check. Thanks!

      Comment

      Previously entered content was automatically saved. Restore or Discard.
      Auto-Saved
      Wink ;) Smile :) Big Grin :D Frown :( Mad :mad: Stick Out Tongue :p Embarrassment :o Confused :confused: Roll Eyes (Sarcastic) :rolleyes: Cool :cool: EEK! :eek:
      x
      Insert: Thumbnail Small Medium Large Fullsize Remove  
      x

      Please enter the six letters or digits that appear in the image below.

      Registration Image Refresh Image

      Sign Up

      Collapse

      To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
      Working...
      X