Announcement

Collapse
No announcement yet.

Prusa i3 Stepper Motors

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Prusa i3 Stepper Motors

    Running into an issue where the stepper motors suddenly ceased to receive any power. I suspect the StepSticks to be the issue. Is there a way to test this without disassembling the entire Arduino set-up? Any help would be greatly appreciated.
    Attached Files

    #2
    It is unlikely that all the stepsticks would go bad at once. First check the green plug on the ramps board. They are known for overheating and causing bad connections. Does the heated bed and hotend go out at the same time? check the 2 fuses near the green power connector.

    Comment

    Working...
    X