Announcement

Collapse
No announcement yet.

Prusa Mendel i3 (Rework) Technical

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Prusa Mendel i3 (Rework) Technical

    Currently constructing a 3d printer with some friends from laser-cut, 3d printed and shipped in materials. The project requires the use of both the 624 bearings and 608 bearings, but I only purchased the 608. The bearings seem to fit and its looking like they are able to take the place of the 624-s aside from minor wobble. Is there any risk to keeping them or am I shooting myself in the foot by not purchasing the 624-s as needed?
    Any help would be appreciated.
    Thanks!

    #2
    you want as little play as possible in bearings compare inside diameter, outside diameter and thickness. they made fit into a hole but inside dia may be off enuf to make a mess. Those bearings are a common size you could most likely find at a local bearing supply co.

    Comment


      #3
      I am confused, these bearings are nowhere near close in size. The 608 bearing has an 8mm center diameter and a 22mm outer diameter, whereas the 624 is 4mm center and 13mm outside. That is an extreme amount of "wobble"

      Comment

      Sign Up

      Collapse

      To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
      Working...
      X