Everything was fine, except my build surface was getting a bit beat up. It was an Ender3 flexible surface. As soon as I changed over and re-leveled, I couldn't get anything to stick to it. I'm running PLA+. I tried temp combinations between 50 and 60 and tip temps between 200 and 205. I put the old surface back on and it wouldn't work either. I changed the tip (0.4mm) with no luck. I tried to get the tip as close as I dare. I used a piece of print paper for a gauge. As it tries to print around a corner, it pulls the previous line with it. after a while it just creates a nest at the tip. The attached is what I ended up with.
Attached Files