Good Morning,
I recently purchased the Ender 5 S1 and Sonic Pad as my first 3D printer. I was setting it up last night and ran into an issue with the auto-leveling while going through the Sonic Pad setup. After I completed the manual bed leveling using the paper method I went into the auto-leveling setup. The print head made the first couple of connections correctly but when it went to the left side of the bed the auto-leveling plunger is off the side of the bed so it will not make contact with the bed. In fact, it will press down hard on the bed and create a fault and stop the auto-leveling process. I have thought about just moving the magnetic bed over about 1/2" as this would ensure contact would be made but this would just be a temporary fix until a more permanent one could be found. Any assistance you can give me with this issue would be great. Please remember I am new and might not understand the language straight off.
Jeff
I recently purchased the Ender 5 S1 and Sonic Pad as my first 3D printer. I was setting it up last night and ran into an issue with the auto-leveling while going through the Sonic Pad setup. After I completed the manual bed leveling using the paper method I went into the auto-leveling setup. The print head made the first couple of connections correctly but when it went to the left side of the bed the auto-leveling plunger is off the side of the bed so it will not make contact with the bed. In fact, it will press down hard on the bed and create a fault and stop the auto-leveling process. I have thought about just moving the magnetic bed over about 1/2" as this would ensure contact would be made but this would just be a temporary fix until a more permanent one could be found. Any assistance you can give me with this issue would be great. Please remember I am new and might not understand the language straight off.
Jeff