Announcement

Collapse
No announcement yet.

Bl touch assistant

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Bl touch assistant

    So guy I have a enders 3 v2 set up ( brand new) with the 1.0.2 firmware and the marlin 4.2.2 board inside).. when I ordered everything ( off amazon and same day ) the bl touch I got was the v1 main board type. so I am going to use the adapter board since I know the plugs wont fit into the bl slot plug way it wired. I was wondering if anyone has a wiring order for the plugs ( on bl end and how they would go into the adapter board. so I can make sure that I don't blow the board. ( as it be a month or better before i could order one.) I downloaded the proper firmware and flash for the bl touch addon ( with adapter ) .. I plan on flashing the board and make sure it still level before I add the touch and flash for it.

    #2
    update for everyone the bl touch v1 works on the ender 3v2 creality board just as is (use the printed board for the sensor) and the flash is same. I had a delay in setting mine due to work and ( I broke my glass board ( dropped it onto a tool on floor from desk) so had to get a new glass.. I also upgrade from the springs ( to yellow) then the silicone bushings and installed a second z axis drive due to the right side seeming to be a couple mm lower every time ( knocking prints over or or shifting them to fail print it seems) with the upgrades i lamost feel like I could of designed a scary printer (inside a thermal take 900 case lol)

    Comment

    Working...
    X