Announcement

Collapse
No announcement yet.

[Anet A8 v1.7] Hotbed's temperature still rising

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    [Anet A8 v1.7] Hotbed's temperature still rising

    Hello everyone.

    I bought a brand new Anet A8 3d printer and set up device correctly. Everything looks fine but I have an issue with hotbed - temperature is still rising even directly after start with stand-by mode.
    This is a problem because at 85°C nozzle stops heating up as well so I can't continue printing.

    The D7 diode is on all the time (even hotbed cable is turned off). D1 diode is on until nozzle is heat up to 190 degree (PLA preheat) and D8 diode is on until nozzle is at 190 degree and after that it's blinking from time to time (motherboard screen in attachment)

    Some other guys had the same problem but I'm not able to find the solution to this issue (links below)

    Any Advices?

    Best regards.

    https://www.youtube.com/watch?v=1XGExYNbpzo
    https://www.youtube.com/watch?v=yrUyGI0u4lc

Working...
X