Announcement

Collapse
No announcement yet.

Anet A8-M

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Anet A8-M

    I have being printing for about 6 months now I changed the firmware two times . One day the X axis only worked in + direction ,I changed the driver (4988) and it worked for a month . After couple of weeks same thing happen and this time both X and Y axis did not work. I replaced drivers set Vref's . checked stepper motors they all seams to be OK. I thought the mother board is bad .Got new mother board( FKB 3.0) installed with new Drivers (4988) still nothing , when I turn power on I can hear a small tug noise and the steppers lock up you cannot move them one way or the other.I changed wires around at the stepper and still nothing. I am member at several forums on Facebook lot of suggestions I tried them all so far no luck.Could someone help me so I can continue to print again.Thank you in advance.

Sign Up

Collapse

To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
Working...
X