Welcome guest. Our website uses cookies to ensure you get the best experience on our website, click here to learn more. To post a thread or reply you must be a member. Registration is fast, simple and absolutely free. So please join our community today!
HI All - new 3d enthusiast and I cannot seem to figure out why I am getting this open web look on vertical surfaces. In fact most of the walls seem to have a denim texture. I have tried increasing the number of walls and thickness. This image was done at .15 and just straight recommended settings from Cura 3.6.0. Printed in PLA at 200c and 10% infill.
That looks like serious under extrusion. Check for a clogg or calibrate e-steps and make sure you have your slicer set for the right diameter of filament (1.75 or 2.85)
Well, hardly any difference and that setting may have only been when I reset the material recently. I did unclog the extruder and am getting good even flow when pushing filament, so any other settings I can try?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment