Welcome guest. Our website uses cookies to ensure you get the best experience on our website, click here to learn more. To post a thread or reply you must be a member. Registration is fast, simple and absolutely free. So please join our community today!
My prints start out okay and print about 3mm of the print, then the extruder moves up about 1cm and then just try’s to print in mid air following the print pattern.
Any idaes?
Regards
Tony
Does the z axis actually jump up or is it moving without any filament coming out, then start flowing again? If the flow stops, monitor your temp of the extruder to make sure you are maintaining temp and it is not cooling mid-print. Check wire connections to make sure you dont have a loose wire on extruder or heater. If the z axis is taking a jump then it could be your software or hardware. You could review the g-code to see if you can see the jump in the code. Try printing from SD card instead of directly from computer. Does it do this on all prints or just specific object?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment