Announcement

Collapse
No announcement yet.

Anet A8 heating issue

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Anet A8 heating issue

    Hi I'm looking for some help for my anet A8 I upgraded the firmware to 1.1.9 . now when I preheat pla the bed gets up to temp the nozzle gets close to 190 and then I have a E1 heating error if I go into the firmware and turn off the thermal runaway I can maintain the heating I would prefer not to do that. I started a print with a thermal runaway turned off and it goes fine for the first two to three layers then the heating on the nozzle drops from 190 and steadily drops there is no fan pointed at the extruder at all. I am using Arduino 1 8.5 and the stock Anet A8 configuration h file and configuration h Advanced file. For the life of me I don't know what to do now.

    #2
    I recently have been fighting a heating issue with my bed, but same may apply. Check your connections for loose connection. It could be that it moves to a certain location and disconnects. Try heating the nozzle and and move your print head around, up and down and see if you get a disconnection. Maybe tap the lines and use voltmeter to monitor. If that isnt it, drop your firmware back to where you came from and verify no hardware issue.

    Comment

    Sign Up

    Collapse

    To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
    Working...
    X