I have been using Simpify3d and used Meshmixer to slice a print into 2 pieces. Simply3d would generate the G-code incorrectly so I have been trying to use Flashprint to see if it would work. I load the model, add support, click on PRINT and a dialog box opens to address ABD/PLA and such. Then I click the okay on the dialog box and it only takes me to the screen to save the current model and never goes to print. No matter where I select PRINT from, I only get the same dialog box to save the model and it never goes to print. Any suggestions as to what I am doing wrong. If worst comes to worst, I'll move it into my Sketchup and redo the whole thing but I would really like to figure out why Flashprint will not work. Also, I never have displayed in the dialog box the selectiable request to PRINT WHEN SLICE DONE. HELP.
Announcement
Collapse
No announcement yet.
Flashprint will not enter print cycle
Collapse
X
-
Finally figured it out. Flashprint allows you to select the Creator Pro as the printer of choice, but does not recognize it as an output device. I went and selected an alternate printer and then selected PRINT and the PRINT WHEN SLICE IS DONE came up with the print dialog window. Sent Flashforge an email about this. What a waste. Flashprint allows you to select one of Flashforge printers but won't let you use it and does not tell you so.
-
, . , . , . , . , . : , , . . . , , , . . « ». , , http://www.uesk.org/katalog/elektrod...din/aic180l4e/ , . . , , . , , . . , . , . , . .
Comment
Comment