Announcement

Collapse
No announcement yet.

Connecting board after reset failed

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Connecting board after reset failed

    Hello.
    I'm going to throw the new firmware into the board... PROCEDURE: I plug the usb cable into the board and pc. Easily connect it under COM3. Then put the boot connector on the boot connector and press the reset button. The board disconnected from the PC and changed to AT90USB1286 (no COM3 port anymore). I'm going to add a new firmware, but there is a problem that I can not see in COM3 port. So I do not want to load a board after reset but without resetting and unplugging the boot connector it's all, and in arduine it's the COM3 port.
    Did anyone meet this problem?

    I have printer PIRX.... with board (Printrboard A based on printrboard) (Printrboard revf --- I think this is my original board)
    Thank you for advice.
    Last edited by Mischelloart; 01-04-2019, 01:56 PM.

    #2
    If you have windows go to the device manager and see if the printer shows up you may to install or update a driver and it will give u a com port which should match the printer

    Comment


      #3
      I see only this after connecting boot connector and press reset button. I need COM port for upload firmware from arduino.

      Comment

      Sign Up

      Collapse

      To post a reply to this thread you must be a member. Registration is fast, simple and absolutely free. Please join our community today!
      Working...
      X