This is on a maker select V2 running 50mm/sec and cura's embedded slicer in repetier-host.. I noticed this so I went ahead and lowered X/Y Accel from 1000 to 800 and jerk from 20 to 8 (This was to alleviate x axis ringing which it did). I have included a pic of the issue I am having as well as my print settings. I'm not sure what I can do about this but It seems to be due to the quick start/stop and perhaps over extrusion while this is occurring. The pics included are the item printed 90 deg apart to see if that would change it (It did not) I then also noticed I have some Y axis ringing even w/ the Z braces and jerk set to 8. Opinions would be great.
Update.. Fixed the ringing w/ bracing of idlers and belt tension but still have those bulges where there are inlays and holes.
https://www.dropbox.com/s/de4s3en0se...25.15.jpg?dl=0
https://www.dropbox.com/s/viy970pznq...24.48.jpg?dl=0
Update.. Fixed the ringing w/ bracing of idlers and belt tension but still have those bulges where there are inlays and holes.
https://www.dropbox.com/s/de4s3en0se...25.15.jpg?dl=0
https://www.dropbox.com/s/viy970pznq...24.48.jpg?dl=0
Comment