This is the Board that came with my Flsun Kossel Delta Linear Version 3D printer kit. Now there are two fans that connect to a top acrylic plate that mounts to this board and two more fans that connect to the Extruder and I am confused on where they all go. The extruder fans are supposed to run continuously so where would I hook up the 4 fans and also the acrylic base this goes on CANNOT be mounted like it shows it's supposed to be in the manual. I purchased this kit off of "3D printers-bay.com" and i've sent them several messages without any reply and I don't want to hook it up to power until everything is setup properly..
Announcement
Collapse
No announcement yet.
NEED HELP!!! wiring the "MakerBase MKS Gen-L V1.0 board" Flsun Kossel Delta
Collapse
X
-
Brandon,
I just finished putting together my FLSun Delta as well and was very amused to see the lack of hookups for the two motherboard fans.
I did a little hunting a found the attached images.
You can use the 5v and ground in the set of four pins that is on the same side as the printer USB cable hook in, but at the opposite end, and then the 5v and ground in AUX 2.
Hope this helps.
Now to keep hunting and see if I can figure out why my Arduino IDE won't see the board on my printer ...
Comment
Comment